Commit graph

2147 commits

Author SHA1 Message Date
Jouni Malinen
4147a2cc64 P2P: Fix p2p_connect join with interface address
Need to fetch P2P Device Address from the peers table in case the
p2p_connect join command uses interface address.
2010-09-09 07:17:20 -07:00
Jouni Malinen
72044390f3 P2P: Add support for cross connection
If enabled, cross connection allows GO to forward IPv4 packets
using masquerading NAT from the P2P clients in the group to an
uplink WLAN connection. This is disabled by default and can be
enabled with "wpa_cli p2p_set cross_connect 1" on the P2P device
interface.
2010-09-09 07:17:20 -07:00
Jouni Malinen
6c6915f3db P2P: Add defined values for P2P Manageability Bitmap 2010-09-09 07:17:20 -07:00
Jouni Malinen
0af196088c P2P: Fix device discoverability to not wait before sending GO Neg Req
When we receive Device Discoverability Response, we need to initiate
new GO Negotiation as quickly as possible to avoid the target client
from going back to sleep. Make sure we do not end up in
P2P_CONNECT_LISTEN state (short Listen mode) in this case.
2010-09-09 07:17:20 -07:00
Jouni Malinen
aefb53bd5d P2P: Disable periodic NoA when non-P2P STA is connected
For now, this applies to the test command that can be used to set
periodic NoA (p2p_set noa). The value are stored and periodic NoA
is enabled whenever there are no non-P2P STAs connected to the GO.
2010-09-09 07:17:20 -07:00
Jouni Malinen
4c08c0bd57 P2P: Include P2P IE in (Re)AssocReq to infra AP if it uses P2P IE
While this is not strictly speaking required by the P2P specification
for a not-P2P Managed Device, this can provide useful information for
the P2P manager AP and may be needed to pass certification tests.
2010-09-09 07:17:20 -07:00
Jouni Malinen
5be5305b7e P2P: Include Extended Listen Timing attribute in (Re)AssocReq
If extended listen timing is enabled, it should be advertised in
(Re)Association Request frames sent to GOs.
2010-09-09 07:17:20 -07:00
Jouni Malinen
31fd64cc2f P2P: Add forgotten allow_cross_connection example 2010-09-09 07:17:20 -07:00
Jouni Malinen
43a3863516 Trigger scan on reload-config only if there are enabled networks 2010-09-09 07:17:20 -07:00
Jouni Malinen
04d8dad5c7 P2P: Wait on operating channel between invitation requests
If running in active GO mode to invite a device to join the group,
wait on operating channel instead of listen channel.
2010-09-09 07:17:20 -07:00
Jouni Malinen
d9d6a58c8f P2P: Fix invitation to active group to use correct operating channel
Invitation Request must use the current operating frequency of the
group, not the default operating channel.
2010-09-09 07:17:20 -07:00
Jouni Malinen
dcf788d1a4 WPS: Fix configuration strings on config reload
Previously, freed memory could be used as device name (and other similar
parameters) when building WPS IE after SIGHUP.
2010-09-09 07:17:20 -07:00
Jouni Malinen
af8ab1ae97 P2P: Use 'Enrollee info' WPS request type in P2P scans
This avoids setting explicit Request-to-Enrollee request when
WPS 2.0 is used.
2010-09-09 07:17:20 -07:00
Jouni Malinen
48e4377093 P2P: Fix WSC IE not to include two Device Name attrs with WPS 2.0 is used 2010-09-09 07:17:20 -07:00
Jouni Malinen
d5b20a73b2 P2P: Fix channel forcing for p2p_connect auth 2010-09-09 07:17:19 -07:00
Jouni Malinen
18eff3a3a7 P2P: Use 0-timeout when inviting to running group as client 2010-09-09 07:17:19 -07:00
Jouni Malinen
131cb37c2d P2P: Allow pre-authorization of invitation to apply to src addr
For client-invites-device case, the pre-authorization of an invitation
to running group will need to allow Invitation Request from specified
address, too. This is for testing uses only.
2010-09-09 07:17:19 -07:00
Jouni Malinen
6d4747a9a2 Add P2P Interface Address into ctrl_iface status output 2010-09-09 07:17:19 -07:00
Jouni Malinen
952f119242 P2P: Add Device Info attribute to Invitation Request
This was added as a mandatory attribute in one of the recent spec
updates.
2010-09-09 07:17:19 -07:00
Jouni Malinen
55a625799f P2P: Add Group Info attr into Probe Response in GO without clients
While there is no real value in this, the spec seems to mark this
attribute as mandatory from GO, so better included it regardless
of whether we have clients or not (the attribute is empty in case
no clients are connected).
2010-09-09 07:17:19 -07:00
Jouni Malinen
80c9582a5f P2P: Add test command for filtering which peers are discovered
"wpa_cli p2p_set peer_filter <MAC address>" can now be used to
only allow a single P2P Device (based on P2P Device Address) to be
discovered for testing. Setting the address to 00:00:00:00:00:00
disables the filter.
2010-09-09 07:17:19 -07:00
Jouni Malinen
6e6963ea86 P2P: Add test mode for SD to force fragmented response 2010-09-09 07:17:19 -07:00
Jouni Malinen
9e00ea1aa3 P2P: Fix country string mismatch validation off-by-one offset
0x04 was being checked from incorrect location when skipping country
code validation.
2010-09-09 07:17:19 -07:00
Jouni Malinen
18708aadfc P2P: Initial support for SD fragmentation (GAS Comeback Request/Response) 2010-09-09 07:17:19 -07:00
Jouni Malinen
2a43101e48 P2P: Fix memory leak in SD service entries
Need to flush stored service entries when wpa_supplicant is being
terminated.
2010-09-09 07:17:19 -07:00
Jouni Malinen
bf608cad56 P2P: Rename SD info not available define to match with spec change 2010-09-09 07:17:19 -07:00
Jouni Malinen
706887fc28 P2P: Stop early when processing not-persistent invitation result 2010-09-09 07:17:19 -07:00
Jouni Malinen
2e062d5d74 P2P: Fix Group ID in Invitation Request from active GO
Need to get P2P Device Address, not the Interface Address.
2010-09-09 07:17:19 -07:00
Jouni Malinen
108def931e P2P: Add command for pre-authorizing an invitation to an active group
This is mainly designed for testing and allows p2p_connect join auth
to be used to accept a specific invitation to an active group that
may be received in the future.
2010-09-09 07:17:19 -07:00
Jouni Malinen
3c5126a41f P2P: Set Device Password ID in WPS M1/M2 per new rules
If the P2P client (WPS Enrollee) uses a PIN from the GO (Registrar),
Device Password ID in M1 & M2 is set to Registrar-specified.
2010-09-09 07:17:19 -07:00
Jouni Malinen
ef922c4a34 P2P: Run a scan before provision discovery in p2p_connect join
This is needed to make sure we have fresh BSS information for the GO.
2010-09-09 07:17:19 -07:00
Jouni Malinen
c381508d88 P2P: Implement power save configuration
wpa_cli p2p_set ps <0/1/2>
wpa_cli p2p_set oppps <0/1>
wpa_cli p2p_set ctwindow <0..> msec
2010-09-09 07:17:19 -07:00
Jouni Malinen
40c03fd40b P2P: Handle p2p_scan tracking in SEARCH state
Previously, only the initial p2p_scan was used to delay starting new
P2P operations. However, this should have applied to the SEARCH state
scans, too.
2010-09-09 07:17:18 -07:00
Jouni Malinen
07a30a66c3 P2P: Do not schedule new remain-on-channel if waiting for drv event
The driver event for remain-on-channel may be delayed in a way that
allows management-frame-received event to be received before
wpa_supplicant knows that the driver is actually already on the
previously requested channel. We should not request a new
remain-on-channel to send a response to just a frame if we are waiting
for the driver to get to the same channel. Instead, just continue
waiting for the driver event.
2010-09-09 07:17:18 -07:00
Jouni Malinen
d6ae995057 P2P: Fix infinite loop on interface selection for Action frame TX
When the first wpa_supplicant interface is not the correct one for
transmitting an Action frame (e.g., P2P Presence Request frame
uses a group interface), the code got stuck in an infinite busy
loop. Fix the iteration to go through the interfaces properly.
2010-09-09 07:17:18 -07:00
Jouni Malinen
962473c136 P2P: Add preliminary P2P Manager AP support for hostapd 2010-09-09 07:17:18 -07:00
Jouni Malinen
df91238b54 P2P: wpa_qui-qt4: Add P2P functionality into the GUI 2010-09-09 07:17:18 -07:00
Jouni Malinen
4f338bea79 P2P: Document new control interface commands and events 2010-09-09 07:17:18 -07:00
Jouni Malinen
42f0101b4d P2P: wpa_cli action calls for P2P group started/removed events 2010-09-09 07:17:18 -07:00
Jouni Malinen
57faa1cee8 wpa_cli: Add P2P commands 2010-09-09 07:17:18 -07:00
Jouni Malinen
9fdd0fada7 P2P: Add disassociation/deauthentication IE notifications 2010-09-09 07:17:18 -07:00
Jouni Malinen
ef7963917c P2P: Add group notification from (re)association request 2010-09-09 07:17:18 -07:00
Jouni Malinen
9bae1be0a1 P2P: Map driver events to P2P event notifications 2010-09-09 07:17:18 -07:00
Jouni Malinen
0c6b310e83 P2P: Show P2P info in ctrl_iface scan results 2010-09-09 07:17:18 -07:00
Jouni Malinen
d23bd8940f P2P: Show P2P Device Address in wpa_cli status 2010-09-09 07:17:18 -07:00
Jouni Malinen
b563b3882e P2P: Add control interface commands for P2P 2010-09-09 07:17:18 -07:00
Jouni Malinen
0817de904e P2P: Optimize scan timeouts for group formation 2010-09-09 07:17:17 -07:00
Jouni Malinen
5f3a6aa0a4 P2P: Add P2P IE into (Re)Association Request frames 2010-09-09 07:17:17 -07:00
Jouni Malinen
0e65037c27 P2P: Add P2P IE into Probe Request frames 2010-09-09 07:17:17 -07:00
Jouni Malinen
f684e608af P2P: Use PSK format in WPS Credential 2010-09-09 07:17:17 -07:00