This can be useful for debugging, so return successfully decrypted TKIP
frame even if the Michael MIC cannot be verified (fragment reassembly
not yet supported) or if the Michael MIC value is incorrect. Add a note
in the frame to point out that the Michael MIC was not verified or is
incorrect.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
Extend Data frame processing (and decryption) to handle +HTC frames by
skipping the HT Control field at the end of the frame header. While this
is not an exact match of the rules in IEEE Std 802.11-2020 for when the
HT Control field is present in frames (e.g., no check of the TXVECTOR
value), this is good enough to cover the most likely used cases.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
This moves the implementation closer to the current IEEE 802.11 standard
since B15 of Frame Control field was renamed to +HTC to match it newer
uses.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
This allows correct processing of Data frames with Mesh Control field by
finding the LLC/SNAP header after that field.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
This resulted in an attempt to dereference a NULL pointer since sta_addr
is not known in this type of a case.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
Buffers passed to rx_data_ip() may not be naturally-aligned, and so we
get unpredictable behavior when we cast that to an IP header. In
particular, this code may crash on ARM.
Signed-off-by: Brian Norris <briannorris@chromium.org>
This previously reserved bit is now used in FTM to help select the
appropriate replay counter. Silence the warning about use of a reserved
bit for this. wlantest does not yet support the actual replay counter
processing for FTM.
Signed-off-by: Jouni Malinen <j@w1.fi>
Use the TKs from the PTK file (-T command line argument) to try to
decrypt encrypted Management frames if no BSS/STA key can be found based
on addresses.
Signed-off-by: Jouni Malinen <j@w1.fi>
Extend the fils_pmk_to_ptk() to also derive Key Derivation
Key (KDK) which can later be used for secure LTF measurements.
Signed-off-by: Ilan Peer <ilan.peer@intel.com>
Extend the wpa_pmk_r1_to_ptk() to also derive Key Derivation
Key (KDK), which can later be used for secure LTF measurements.
Signed-off-by: Ilan Peer <ilan.peer@intel.com>
Extend the wpa_pmk_to_ptk() to also derive Key Derivation
Key (KDK), which can later be used for secure LTF measurements.
Update the wpa_supplicant and hostapd configuration and the
corresponding WPA and WPA Auth state machine, to allow enabling of KDK
derivation. For now, use a testing parameter to control whether KDK is
derived.
Signed-off-by: Ilan Peer <ilan.peer@intel.com>
S1G beacons save a few bytes by not requiring the RSNE in beacon if RSN
BSS is configured. Handle this in wlantest by only clearing RSNE from
the BSS info if frame is a Probe Response frame.
Signed-off-by: Thomas Pedersen <thomas@adapt-ip.com>
Now that we no longer leave build artifacts outside the build folder, we
can clean up the gitignore a bit. Also move more things to per-folder
files that we mostly had already anyway.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
This is something I hadn't previously done, but there are
cases where it's needed, e.g., building 'wlantest' and then
one of the tests/fuzzing/*/ projects, they use a different
configuration (fuzzing vs. not fuzzing).
Perhaps more importantly, this gets rid of the last thing
that was dumped into the source directories, apart from
the binaries themselves.
Note that due to the use of thin archives, this required
building with absolute paths.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Instead of building in the source tree, put most object
files into the build/ folder at the root, and put each
thing that's being built into a separate folder.
This then allows us to build hostapd and wpa_supplicant
(or other combinations) without "make clean" inbetween.
For the tests keep the objects in place for now (and to
do that, add the build rule) so that we don't have to
rewrite all of that with $(call BUILDOBJS,...) which is
just noise there.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Clean up in a more common fashion as well, initially for ../src/.
Also add $(Q) to the clean target in src/
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Some things are used by most of the binaries, pull them
into a common rule fragment that we can use properly.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
The case where a single 0xdd octet without any 0x00 octets is used as
padding was addressed incorrectly and that ended up truncating one octet
of the actual plaintext version of the Key Data value. Fix this by
removing the unnecessary change to the p pointer before calculating the
new length since p is already pointing to one past the last octet of the
full plaintext.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
We're doing a sort of bounds check, based on the previous loop, but only
after we've already tried to read off the end.
This squashes some ASAN errors I'm seeing when running the ap_ft hwsim
test module.
Signed-off-by: Brian Norris <briannorris@chromium.org>
Verify that RSNE, MDE, and FTE have valid information in FT
Reassociation Response frames. In addition, decrypt GTK, IGTK, and BIGTK
from the frame.
Signed-off-by: Jouni Malinen <j@w1.fi>
It is expected for the STA entry on the target AP to move directly from
State 1 to State 3 when performing FT over-the-DS (i.e., FT Action
Request/Response frame exchange through the old AP followed by
Reassociation Request/Response frame exchange with the target AP).
Signed-off-by: Jouni Malinen <j@w1.fi>
The ar operations with embedded libraries were not exactly portable
or strictly speaking necessary. Drop that library completely to make
this more portable.
Signed-off-by: Jouni Malinen <j@w1.fi>
The PN and RSC are already printed in the "replay detected" debug
message so there is no point in having separate hexdumps of the same
values immediately after that.
Signed-off-by: Jouni Malinen <j@w1.fi>
If no WEP keys are available, there is not going to be an attempt to
decrypt the frame, so don't claim decryption failed.
Signed-off-by: Jouni Malinen <j@w1.fi>
Update TPTK to PTK if a valid EAPOL-Key msg 2/4 and 3/4 are available,
but 4/4 is missing. This avoids certain cases where the new TK could be
derived, but it was not being used to try to decrypt following encrypted
frames.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
All the "Failed to decrypt frame" debug prints were confusing since
those were not supposed to be shown unless there were one or more real
TKs available. The recently added check for zero TK added these notes
for that case which is not really correct, so get rid of them.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
This makes it easier to analyze certain encryption issues. Also print
out an error at the default INFO debug verbosity with the frame number.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
Previously, missing CCMP protection on Robust Management frames was
reported based on the STA having indicated MFPC=1. That is not accurate
since the AP/BSS may have MFPC=0. Report this failure only if both the
AP and STA have indicated MFPC=1, i.e., when PMF has been negotiated for
the association.
Signed-off-by: Jouni Malinen <j@w1.fi>
If no Beacon or Probe Response frame has been seen in the capture, use
the IEs from EAPOL-Key msg 3/4 to set up BSS information.
Signed-off-by: Jouni Malinen <j@w1.fi>
The previous implementation tried to update STA IE information based on
EAPOL-Key msg 2/4 to be able to handle captures that do not include the
(Re)Association Request frame. This was not sufficient (OSEN was not
included) and was done too late (the parsed information is needed for
PMK-to-PTK derivation).
Move the IE update step to happen before trying to derive the PTK if no
(Re)Association Request frame has been seen.
Signed-off-by: Jouni Malinen <j@w1.fi>
Fetch the BIGTK from EAPOL-Key msg 3/4 and use it to validate MME in
Beacon frames when the AP uses Beacon protection.
Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
