Add a QCA vendor attr to disable auto resume beacon reporting

The driver automatically starts beacon reporting if it pauses the beacon
reporting for any reason other than disconnection. In specific cases,
userspace may not want the beacon reporting to be automatically resumed
after a pause. Add interface support for userspace to specify driver not
to start beacon reporting automatically after a pause.

Signed-off-by: Jouni Malinen <jouni@codeaurora.org>

src/common/qca-vendor.h

@@ -560,7 +560,10 @@ enum qca_radiotap_vendor_ids {
  *	resumed or not by the driver/firmware later will be reported to
  *	userspace using the QCA_WLAN_VENDOR_ATTR_BEACON_REPORTING_AUTO_RESUMES
  *	flag. The beacon reporting shall be resumed for all the cases except
- *	disconnection case as indicated by setting
+ *	either when userspace sets
+ *	QCA_WLAN_VENDOR_ATTR_BEACON_REPORTING_DO_NOT_RESUME flag in the command
+ *	which triggered the current beacon reporting or during any disconnection
+ *	case as indicated by setting
  *	QCA_WLAN_VENDOR_ATTR_BEACON_REPORTING_PAUSE_REASON to
  *	QCA_WLAN_VENDOR_BEACON_REPORTING_PAUSE_REASON_DISCONNECTED by the
  *	driver.
@@ -7033,6 +7036,23 @@ enum qca_wlan_vendor_attr_beacon_reporting_params {
 	 * QCA_WLAN_VENDOR_BEACON_REPORTING_OP_PAUSE. NLA_FLAG attribute.
 	 */
 	QCA_WLAN_VENDOR_ATTR_BEACON_REPORTING_AUTO_RESUMES = 12,
+	/* Optionally set by userspace to request the driver not to resume
+	 * beacon reporting after a pause is completed, when the
+	 * QCA_WLAN_VENDOR_ATTR_BEACON_REPORTING_OP_TYPE is set to
+	 * QCA_WLAN_VENDOR_BEACON_REPORTING_OP_START. NLA_FLAG attribute.
+	 * If this flag is set, the driver will not resume beacon reporting
+	 * after any pause in beacon reporting is completed. Userspace has to
+	 * send QCA_WLAN_VENDOR_BEACON_REPORTING_OP_START command again in order
+	 * to initiate beacon reporting again. If this flag is set in the recent
+	 * QCA_WLAN_VENDOR_BEACON_REPORTING_OP_START command, then in the
+	 * subsequent QCA_WLAN_VENDOR_BEACON_REPORTING_OP_PAUSE event (if any)
+	 * the QCA_WLAN_VENDOR_ATTR_BEACON_REPORTING_AUTO_RESUMES shall not be
+	 * set by the driver. Setting this flag until and unless there is a
+	 * specific need is not recommended as there is a chance of some beacons
+	 * received after pause command and next start command being not
+	 * reported.
+	 */
+	QCA_WLAN_VENDOR_ATTR_BEACON_REPORTING_DO_NOT_RESUME = 13,
 
 	/* Keep last */
 	QCA_WLAN_VENDOR_ATTR_BEACON_REPORTING_LAST,