QCA vendor attribute to configure NSS

Defines the attribute in SET(GET)_WIFI_CONFIGURATION to dynamically
configure NSS.

Signed-off-by: Jouni Malinen <jouni@codeaurora.org>
This commit is contained in:
Sunil Dutt 2020-05-27 16:55:49 +05:30 committed by Jouni Malinen
parent 747c69fa90
commit 960e8e5334

View file

@ -2183,6 +2183,18 @@ enum qca_wlan_vendor_attr_config {
*/
QCA_WLAN_VENDOR_ATTR_CONFIG_RX_STBC = 69,
/* 8-bit unsigned value. This attribute is used to dynamically configure
* the number of spatial streams. When configured in the disconnected
* state, the updated configuration will be considered for the
* immediately following connection attempt. If the NSS is updated after
* the connection, the updated NSS value is notified to the peer using
* the Operating Mode Notification/Spatial Multiplexing Power Save
* frame. The updated NSS value after the connection shall not be
* greater than the one negotiated during the connection. Any such
* higher value configuration shall be returned with a failure.
*/
QCA_WLAN_VENDOR_ATTR_CONFIG_NSS = 70,
/* keep last */
QCA_WLAN_VENDOR_ATTR_CONFIG_AFTER_LAST,
QCA_WLAN_VENDOR_ATTR_CONFIG_MAX =