hostapd: Reset channel switch parameters on interface disable

Previously, when an AP interface was disabled through a control
interface DISABLE command during a channel switch window, the interface
could not be reenabled due to beacon setup failure (which validates if
CSA is in progress).

Fix this by clearing channel switch parameters while disabling the
hostapd interface.

Signed-off-by: Sriram R <srirrama@codeaurora.org>
This commit is contained in:
Sriram R 2018-09-14 16:36:06 +05:30 committed by Jouni Malinen
parent 2f186d598a
commit 7b2ca5cf0d

View file

@ -2620,6 +2620,11 @@ int hostapd_disable_iface(struct hostapd_iface *hapd_iface)
!!(hapd_iface->drv_flags &
WPA_DRIVER_FLAGS_AP_TEARDOWN_SUPPORT);
#ifdef NEED_AP_MLME
for (j = 0; j < hapd_iface->num_bss; j++)
hostapd_cleanup_cs_params(hapd_iface->bss[j]);
#endif /* NEED_AP_MLME */
/* same as hostapd_interface_deinit without deinitializing ctrl-iface */
for (j = 0; j < hapd_iface->num_bss; j++) {
struct hostapd_data *hapd = hapd_iface->bss[j];
@ -3428,7 +3433,6 @@ hostapd_switch_channel_fallback(struct hostapd_iface *iface,
const struct hostapd_freq_params *freq_params)
{
int vht_seg0_idx = 0, vht_seg1_idx = 0, vht_bw = VHT_CHANWIDTH_USE_HT;
unsigned int i;
wpa_printf(MSG_DEBUG, "Restarting all CSA-related BSSes");
@ -3470,10 +3474,8 @@ hostapd_switch_channel_fallback(struct hostapd_iface *iface,
/*
* cs_params must not be cleared earlier because the freq_params
* argument may actually point to one of these.
* These params will be cleared during interface disable below.
*/
for (i = 0; i < iface->num_bss; i++)
hostapd_cleanup_cs_params(iface->bss[i]);
hostapd_disable_iface(iface);
hostapd_enable_iface(iface);
}