P2P: Handle INTERFACE_DISABLED event on a P2P GO interface

An INTERFACE_DISABLED event received on an interface that is
currently operating a P2P GO means that the group session ended.
In such a case, if the interface was dynamically added remove it, and
if not, remove all the network blocks that are temporary, assuming
that if needed a new session will be started by an external entity.

The use case was triggering rfkill (both SW and HW). This case popped up
as part of a testing cycle, where after a toggle in the rfkill state,
the result was that the interface was not deleted, but on the other hand
the wpa_supplicant did not configure the kernel to re-start the AP
functionality again.

Signed-hostap: Ilan Peer <ilan.peer@intel.com>
This commit is contained in:
Ilan Peer 2013-09-02 15:40:59 +03:00 committed by Jouni Malinen
parent 336167c80e
commit 6f72577f29

View file

@ -3196,6 +3196,20 @@ void wpa_supplicant_event(void *ctx, enum wpa_event_type event,
break; break;
case EVENT_INTERFACE_DISABLED: case EVENT_INTERFACE_DISABLED:
wpa_dbg(wpa_s, MSG_DEBUG, "Interface was disabled"); wpa_dbg(wpa_s, MSG_DEBUG, "Interface was disabled");
#ifdef CONFIG_P2P
if (wpa_s->p2p_group_interface == P2P_GROUP_INTERFACE_GO ||
(wpa_s->current_ssid && wpa_s->current_ssid->p2p_group &&
wpa_s->current_ssid->mode == WPAS_MODE_P2P_GO)) {
/*
* The interface was externally disabled. Remove
* it assuming an external entity will start a
* new session if needed.
*/
wpas_p2p_disconnect(wpa_s);
break;
}
#endif /* CONFIG_P2P */
wpa_supplicant_mark_disassoc(wpa_s); wpa_supplicant_mark_disassoc(wpa_s);
wpa_supplicant_set_state(wpa_s, WPA_INTERFACE_DISABLED); wpa_supplicant_set_state(wpa_s, WPA_INTERFACE_DISABLED);
break; break;